Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 7 replies
  • Answers 1 answer
  • Subscribers 29 subscribers
  • Views 2005 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPSEC connect - remote access - not working from LAN zone

lukg

IPSEC connect - remote access - is not working when the connection is originating in LAN zone. It is working from WAN no problem.

Any idea how to fix it so IPSEC connect client can connect from Internal network?



This thread was automatically locked due to age.
Parents
  • 0

    Could be different issues. The Appliance using one Interface for Ipsec. You select this interface. The client is using this IP: Is the client using a DNS or IP to establish the connection? Do you see the Port500 packets in packet capture?

    __________________________________________________________________________________________________________________

  • 0 in reply to LuCar Toni

    Yes but it says - Status Violation Local_ACL

    UDP
    55110,500
    0
    0
    Violation
    Local_ACL
  • 0 in reply to lukg

    Local ACL sounds like, the Client is not sending packets to the WAN Interface, instead to the LAN Interface.

    Do you use a DNS record and this is resolved on the LAN? 

    __________________________________________________________________________________________________________________

Reply
  • 0 in reply to lukg

    Local ACL sounds like, the Client is not sending packets to the WAN Interface, instead to the LAN Interface.

    Do you use a DNS record and this is resolved on the LAN? 

    __________________________________________________________________________________________________________________

Children
Cookie Information Banner