This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

The lag does not work with 802.3ad but works with active / backup when a configure HA.

Hello,

I have a problem on the lag when I want to do active / passive ha. When I activate 802.3ad on the second appliance the lan collapses and does not work any more whereas if I put the lag in active backup mode it works.
Is it possible to do on HA with the lag in 802.3ad?

Thanks a lot

This thread was automatically locked due to age.

0 LuCar Toni over 3 years ago

What is the setup?
Because LAG is all the time "appliance based". So you can LAG Port1+2 on Appliance 1. And you have to do the same on Port1+2 on Appliance 2.

There is no possibility to LAG Port1 and Port1 of Appliance 1 and Appliance2.
Cancel
Vote Up 0 Vote Down

Cancel
0 Xitey over 3 years ago in reply to LuCar Toni

Both appliances have two lags with two ports configured identically. On the second appliance as soon as I activate 802.3ad it crashes the lan but if I switch the lag to ative backup the lan remains operational.
Cancel
Vote Up 0 Vote Down

Cancel