Guest User!

You are not Sophos Staff.

Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 2 replies
  • Subscribers 27 subscribers
  • Views 845 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Random WAN ISP Connection

Charles Ng1

Hi, Good day all

i have Sophos XG 135 Firewall setup with three incoming ISPs connection for three of my three VLAN groups.

However, recently after the recent upgrade of firewall firmware. I found that the connection seems messed up. Its currently not following my firewall setting.

I tried to configure and update the Routing - SD Wan Policy Routing but failed to set

> e.g SD Wan 1 -- configured with Interface --> Port 3 (for ISP#3 connection) . Source Network: Any    Destination Network:  To my desired VLAN group for this WAN connection.

and same goes for my others two SD WANs with seperate desired destination network

But, this policy seems failed on the desired action.

Please advice. Thanks.



This thread was automatically locked due to age.
Parents
  • 0

    Inbound traffic needs a most likely a DNAT, not a SD-WAN route. Likely you need to change the traffic and not simply route it. 

  • 0 in reply to LuCar Toni

    Hiye Lucar,

    Thanks for your info. Ah ha... Found it under the Protect --> Rules & Policies --> NAT Rules.  However, all the available rules was unable to edit and grey out.  its showing something like "fw <id> migrated NAT Rules".  i believed, this could be the main culprit.  Shall i re-create a new Rules or any how or idea - to enable the edit on the existing migrated rules ?

    Thanks and appreciate.

Reply
  • 0 in reply to LuCar Toni

    Hiye Lucar,

    Thanks for your info. Ah ha... Found it under the Protect --> Rules & Policies --> NAT Rules.  However, all the available rules was unable to edit and grey out.  its showing something like "fw <id> migrated NAT Rules".  i believed, this could be the main culprit.  Shall i re-create a new Rules or any how or idea - to enable the edit on the existing migrated rules ?

    Thanks and appreciate.

Children
No Data