Hi,
Looking at deploying a new site with a Sophos SD-RED60 and as there will be a few switches at this site would like to put some redundant switching options in using STP. I can't see any options in a RED interface for STP. Is it possible to configure STP for the LAN ports on a RED appliance?
Thanks,
Phil
Phil - I am not sure of the topology you are looking to put in place, but picture the RED's as a layer 2 bridge between sites. (Deployed in Standard/Unified mode) STP can be configured on the Sophos Firewalls themselves, but not on the SD-RED's since they usually just link sites together and perform basic forwarding/routing functions depending on the deployment scenario. Refer to the below. If STP is a requirement, you could look at deploying a small XGS 107 or above firewall in the remote sites.
Sophos Firewall: RED (Remote Ethernet Device) technical training guide
