Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos XGS Bypass NAT

Hi Sophos Community

I have a Sophos XGS 3100 Firewall that is connected to our ISP and also to our switch which then connects to VMWare ESXi servers. We have local IP addresses for one of our VMWare servers and its VMs which is then NATted by Sophos.

I would like a couple of these VM's to use public IP addresses rather than local IP addresses with NAT. Is this possible with Sophos XGS?

Thank you in advance for your help.

Kind regards



This thread was automatically locked due to age.
Parents
  • Yes, it is. You need to create a new interface with IP address range you wish to use. How big is the address range eg /29 or /28 that you have been assigned?
    in theory you should use WAF but I am not sure you can create a WAF rule without Nat.

    ian

  • Thanks for your reply. The address range is a /24. The main gateway at the moment at ISP is xxx.xxx.xxx.1, it sounds like I need to assign IP address to the interface xxx.xxx.xxx.2 and then route traffic from that to xxx.xxx.xxx.1?

    Thanks

Reply Children