Hello,
I'm trying to link two sites using IPsec but when i get to local WAN port section i don't see my WAN interface.
Please advise what i might be doing wrong.

This thread was automatically locked due to age.
Hello,
I'm trying to link two sites using IPsec but when i get to local WAN port section i don't see my WAN interface.
Please advise what i might be doing wrong.

Hello George,
you are sitting behind a router, who has the "WAN-Port" IP by chance? So that your Sophos firewall has a transfer-net in between?
Could you provide a simple network diagram?
Mit freundlichem Gruß, best regards from Germany,
Philipp Rusch
New Vision GmbH, Germany
Sophos Silver-Partner
If a post solves your question please use the 'Verify Answer' button.
Hello George,
you are sitting behind a router, who has the "WAN-Port" IP by chance? So that your Sophos firewall has a transfer-net in between?
Could you provide a simple network diagram?
Mit freundlichem Gruß, best regards from Germany,
Philipp Rusch
New Vision GmbH, Germany
Sophos Silver-Partner
If a post solves your question please use the 'Verify Answer' button.
https://support.sophos.com/support/s/article/KB-000035805?language=en_US
This article contains a list of unsupported bridge interface gaps.
For more information about the Sophos Firewall interfaces, go to its Interfaces section.
-----------------------
Thank & Regards,
Nilesh Mojidra
If a post solves your question, use the 'Verify Answer' link.