configure interface via cli

Dear comminity,

is there any chance to configure interfaces via console?

I've done an Sophos Migration Assistant restore on a new XG430 release SFOS 18.0.4 MR-4 and when the XG430 booted it configure the interface as PortA1, PortA2, PortA3, ecc. but in the new hardware i don't have the interface expantion module A. 

I've now only access by cli to XG430 and i see the interface Port1, Port2, Port3 ecc by the command:

console> show network interfaces
Port1 Zonetype:UNBOUND MAC Address:C8:4F:86:09:35:AC MTU:1500
Speed:65535Mb/s Full Duplex Auto Negotiation:yes
BROADCAST MULTICAST
RX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 frame:0
TX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 carrier:0

Port10 Zonetype:UNBOUND MAC Address:C8:4F:86:09:35:B5 MTU:1500
Speed:65535Mb/s Full Duplex
BROADCAST MULTICAST
RX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 frame:0
TX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 carrier:0

Port2 Zonetype:UNBOUND MAC Address:C8:4F:86:09:35:AD MTU:1500
Speed:65535Mb/s Full Duplex Auto Negotiation:yes
BROADCAST MULTICAST
RX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 frame:0
TX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 carrier:0

But If I try to configure the ports by the interaction menu: 

1.  Network  Configuration

 1. Interface Configuration

I see only the interface named PortA1, PortA2, PortA3, ecc.. 

Network configuration Menu

1. Interface Configuration
2. DNS Configuration
0. Exit

Select Menu Number [0-2]: 1
Sophos Firmware Version SFOS 18.0.4 MR-4

Network Settings
Interface Name : PortA1 (Physical)
Zone Name : WAN

Then I can't connect on it by web gui.

Thank you