This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Webadmin: You do not have the privilege to add/modify the configuration

What is this again?

This happens since a few minutes while clicking without changing anything in different menu's on the webadmin. Noticed by me and a colleague at the same time.

This comes and goes like random.

Text may be shown on top of the screen:

You do not have the privilege to access the page or perform the operation
You do not have the privilege to add/modify the configuration

This thread was automatically locked due to age.

Parents

0 LHerzog over 4 years ago

this message has gone now just like it appeared.
Cancel
Vote Up 0 Vote Down

Cancel
0 FormerMember over 4 years ago in reply to LHerzog

Hi LHerzog,

Are you able to make any configuration changes on this appliance? Is it in HA? And you're connected to the Primary unit?

Thanks,
Cancel
Vote Up 0 Vote Down

Cancel
0 LHerzog over 4 years ago in reply to FormerMember

Hi,

yes, I can now and could change config while the message was showing up.

It's HA and sure - I'm connected to the primary.

Shortly before the message appeared, I modified remote access:

Support Access Management were changed by 'myname' from '10.myip' using 'GUI'
Cancel
Vote Up 0 Vote Down

Cancel
0 FormerMember over 4 years ago in reply to LHerzog

Hi LHerzog,

Is there any Device access profile configured for the admin user? With the Device access profile, you could make certain configuration options read-only.

Thanks,
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 FormerMember over 4 years ago in reply to LHerzog

Hi LHerzog,

Is there any Device access profile configured for the admin user? With the Device access profile, you could make certain configuration options read-only.

Thanks,
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data