Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 1030 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Question about XG 115 Port/network Configuration

Courtney Mitchell

I am a total novice concerning the XG  firewalls. I have an new Xg-115 Rev 3. The device has 4 physical ports and I would like to use PORT 4 for a separate network that can see the internet via Port 2(WAN). In addition I want to allow My LAN (PORT 1) to be able to see devices on the network that will be on PORT 4. 

Example: PORT 1, ZONE = LAN, IP = 192.168.1.1

                 PORT 4,  ZONE = IOT, IP = 192.168.2.1

                 PORT 2, ZONE=WAN, IP (obtained  from ISP)

Here is my problem:  Out of the Box physical PORTS 1, 3,4 are members of bridge port Br0, with IP address of 192.168.1.1.  How do I use Physical PORT 4 for a separate network address without using VLANS?  I want PORT 4 for as separate network interface with the new IP address of 192.168.1.2.1. 

I may be making this harder that it should be but as I said,  I am a newbie to the Sophos XG. Help :-)



This thread was automatically locked due to age.
Parents
  • 0

    You can break the bridge by deleting the interfaces from it and then setup your required networks.

    ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    Thanks rfCat_vk!  When I edit br0 it will only allow me to remove port 3, not ports 1 & 4 from the membership.   So, I must delete the interface bridge (br0) and then create 2 new bridges each with its own IP, member ports, and zones assigned, correct?  Will this affect any of the FW Rules previously configured?  

  • 0 in reply to Courtney Mitchell

    You can achieve what you want using firewall rules rather than bridges. Also the bridge will only have one ip range.

    you will need to redo your firewall rules.

    ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

Reply Children
Cookie Information Banner