Recently bought new hardware to replace our 4+ year old XG's. Was looking to go from XG125w rev 1 to XG125 rev 3 (non wifi). Had both the old and new upgraded to latest 18 MR4 firmware, went through the entire firewall cleaning everything up (deleted all rules not used in last three months, old services, exceptions, etc). Did a backup and tried to restore on the new firewall but just get:
Backup cannot be restored on current device
Is this because of the 125w -> 125 difference or something else? I really would rather not have to recreate the config from scratch....I have two 125w's -> 125 and also a 310 rev 1 -> 310 rev 2 after these that I now worry will have issues.
Side note: Both 125 rev 3's failed to get through the setup wizard. Both locked up on updating firmware....let them sit for over a hour each before rebooting. Looking stuff up that is apparently a issue that's never been fixed. (see https://community.sophos.com/xg-firewall/f/discussions/101655/firmware-upgrade-during-initial-setup-fails or https://community.sophos.com/xg-firewall/f/discussions/122285/sfos-v18-initial-setup )
This thread was automatically locked due to age.
