This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IP Interface change (WWAN) and SDWAN routing with tunnel interface [xfrm1] (v18)

I have a WWAN (an USB Internet key) that I use as "backup", it's active and use for some specific traffic....

The configuration of WWAN is show below:

I need to change Gateway IP because I have a remote network (192.168.1.0/24) that I reached with IPSEC Tunnel interface...

When WWAN is UP I can not reach remote net (192.168.1.0/24).

Second question:

I need to change routing precedence to: static route, SD-WAN route, VPN route (to use static route show previously) because with SD-WAN policy routing I can not select IPSec tunnel interface... it's correct?

Thanks!

This thread was automatically locked due to age.

0 GavinDaniels over 4 years ago

Hello

Wouldn't it be easier to just change the IP details of the USB stick to something not used over your extended network?
Cancel
Vote Up 0 Vote Down

Cancel
0 GabrieleD over 4 years ago in reply to GavinDaniels

It is the internet key (Gateway) that releases the IP address... But I don't know how to change that IP and possibly the IPs it releases
Cancel
Vote Up 0 Vote Down

Cancel