Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 6 replies
  • Answers 3 answers
  • Subscribers 27 subscribers
  • Views 2045 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG 115 and Static IP address from ISP

Noel Hernandez

I have DSL modem from Centurylink that has one port using a static IP address that is connected to a Linksys Smart Router that has the Static IP address currently setup, i have tried to install the XG 115 using port 2 with the cable coming from the Centurylink port that has the static ip configuration already setup on modem, i have tried to configure port 2 in the XG 115 with the static info but it will not connect to the internet.  What am i doing wrong, i a new to Sophos firewall XG115 and would like to protect my home network. 

Thank You



This thread was automatically locked due to age.

Top Replies

  • +1 suggested

    I think your issue will be your smart router which should not be between your modem and the XG. You setup the modem in bridge mode and configure the XG interface with the fixed IP address.

    Ian

    Jump to answer
Parents Reply Children
  • 0 in reply to emmosophos

    Thank you i was able to use CLI to connect directly using the HDMI to a monitor and a usb keyboard to reset it to factory settings, i am now able to connect to the XG firewall.  I ended up just connecting the XG to one of the ports on the Linksys smart router, which then changed the Port2 Wan settings to a static IP address for the Router gateway, now i have a connection green status light on the xg webadmin home page.  I think i am good now... thanks for all your help