Guest User!

You are not Sophos Staff.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 6 replies
  • Answers 1 answer
  • Subscribers 30 subscribers
  • Views 1301 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Upgrading to v18 causes HA Pair to stop working.

Edward Higgins

I have recently attempted to update XG230's and XG330's to v18.  All my companies firewalls are in an HA cluster.  The update breaks the cluster causing one of the units to be unreachable and unavailable for the HA Pairing.  

Do I need to unpair the HA cluster and perform the updates separately?  I have had it fail 3 times on separate pairs.  Not a good track record.



This thread was automatically locked due to age.
Parents
  • 0

    I had the same problem. I have 2 XG310 in HA and it broke HD cluster when doing the update. I was running V17.5 MR14 on both XG310. It prompt me saying both firewalls will reboot simultaneously but decided to only update auxiliary device to V18 causing both devices to have identical IP setup and act both as primary. Caused bit of network drama until I took the auxiliary device offline. Since then I have taken HA off and plan is to update V17 one to V18 and re-create the cluster again. 

Reply
  • 0

    I had the same problem. I have 2 XG310 in HA and it broke HD cluster when doing the update. I was running V17.5 MR14 on both XG310. It prompt me saying both firewalls will reboot simultaneously but decided to only update auxiliary device to V18 causing both devices to have identical IP setup and act both as primary. Caused bit of network drama until I took the auxiliary device offline. Since then I have taken HA off and plan is to update V17 one to V18 and re-create the cluster again. 

Children
No Data