Not able to access XG using wan port deployed on VMWARE(ESXI6.7)

You're not really giving away a lot of info... 

As for your first question about not being able to access XG through WAN; did you allow HTTPS access on WAN interface? (And if so, think about if that is what you really want since that means anyone can reach the service).

About not being able to route traffic to firewall. What exactly do you mean with that? What do you want to route to the firewall from where? If possible add a drawing of your network.

Traffic route to firewall means VM's which are in same network those traffic should go to Firewall.

Likely a MAC Issue. You need to figure out, if you Adapter matching those, you expect to be on your vSwitch. 

Do I need to check MAC address of NiC's which are attached to VM?

Yes - Use the console, login to XG, go to the Advanced Shell (5 - 3) and check via ifconfig, if all your Ports are actually as intended connected to the matching vSwitch Ports. 

I checked and found below details:

PortB : 00:50:56:09:0E:B0

PortA : 00:50:56:09:0E:B1

Please suggest is this fine or need to change.

That is not what i meant by my initial suggestion. If you have multiple interfaces, the vSwitch is connecting them together. If you alter the XG after deployment or add/remove interfaces, those interfaces can be mixed. 

You need to verify, if all your used interfaces are actually the same as intend to be on the vSwitch. 

I used NIC of two different vlan's

We are running ESXI 6.7 version of VMWARE

And those MACs you are using on both VLANs in the vSwitch matches the NICs on the XG firewall console, correct?

Yes

Yes

Then you should start to tcpdump the outgoing packets and see, what is happening on this End. 

as you can perform tcpdumps, you can verify, if the vswitch is causing the problem or XG. Likely its a vSwitch configuration issue.