Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 280 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bridging a interface and rules

David Zambrano

Our ISP only gave us one active port to the internet and our XG is using that sole port. I have the need to install another appliance at the perimeter and would hate to have to install a switch when I'd like to use an unused port on the XG. Is it possible to setup a bridge on the WAN port without having to redo all the rules? This is on a 115w with v18 mr3



This thread was automatically locked due to age.
  • 0

    Hello David,

    Thank you for contacting the Sophos Community!

    So, if you have Port2 as WAN, and Port3 is empty and you want to bridge these two ports together as a WAN interface it won't allow you to. 

    If you want to install both of your devices with a public WAN you would, unfortunately, have to put a small switch between the XG and the Modem of your ISP.

    Regards,

  • 0

    Never go this route down. A firewall product should not be used to replace an entire switch. You have to create network bridges on XG, which essentially work but i do not recommend.