This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Enable *** (C-I-P-A) Compliance

Hello,

I think I am missing something obvious, but I can't seem to find a pre-defined content filter or policy for restricting web traffic based on *** (not sure why that acronym is being replaced by asterix - C I P A) compliance. Could someone point me to the right spot to set that up on my XG (v18)?

Thanks!

This thread was automatically locked due to age.

Parents

0 FormerMember over 4 years ago

Hi Stephen Youngquist,

Thank you for reaching out to the Community!

Could you please provide some steps or screenshot of what you are trying to configure on your firewall?

Thanks,
Cancel
Vote Up 0 Vote Down

Cancel
0 Stephen Youngquist over 4 years ago in reply to FormerMember

Thanks for the reply. Some steps or a screenshot are, unfortunately, what I am looking for. I am just wondering where the pre-defined filters for *** compliance are to be found - they are referenced in various literature, but none specifically about the setup.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Stephen Youngquist over 4 years ago in reply to FormerMember

Thanks for the reply. Some steps or a screenshot are, unfortunately, what I am looking for. I am just wondering where the pre-defined filters for *** compliance are to be found - they are referenced in various literature, but none specifically about the setup.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data