Sophos Firewall

Discussions Need some help with 4in6 he-tunnel

Sophos Firewall requires membership for participation - click to join

Thread Info

State Not Answered
Locked Locked
Replies 3 replies
Subscribers 29 subscribers
Views 650 views
Users 0 members are here

Options

Suggested

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need some help with 4in6 he-tunnel

dirkkotte over 4 years ago

Hi,

I configure the he-tunnel interface with Local endpoint=Client IPv4 Address and Remote endpoint=Server IPv4 Address from HE config page.

I configure the Client IPv6 Address at the WAN-interface and Server IPv6 Address as gateway.

i am able to ping the WAN-interface IPv6 address but unable to ping the Server IPv6 Address from XG.

How can check if tunnel is up? How do i reach the HE IPv6 gateway?

Some ideas?

TIA.

This thread was automatically locked due to age.

0 LuCar Toni over 4 years ago

Talking about DHCPv6-PD?

https://ideas.sophos.com/forums/330219-xg-firewall/suggestions/11546439-add-options-for-ipv6-dhcpv6-pd
Cancel
Vote Up 0 Vote Down

Cancel
0 dirkkotte over 4 years ago in reply to LuCar Toni

Hi, Thanks for the answer,

My ISP doesn't support native IPv6. So I build a 6in4 tunnel. Works at UTM/SG one week ago without problems.

But I can't get it to work on the XG.

Following the forum/community instructions ... without success.

I think the first step is reaching the remote gateway, but I am unable to ping this address from LAN and XG.
Cancel
Vote Up 0 Vote Down

Cancel
0 Williams Joseph over 4 years ago

Hiii...i configure the he-tunnel interface with local endpoint=client ipv4 Address and remote endpoint=server ipv4 address from HE configue Walgreenslistens
Cancel
Vote Up 0 Vote Down

Cancel