Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 12 replies
  • Answers 1 answer
  • Subscribers 30 subscribers
  • Views 2709 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WAN PORT

Mohamed Arbaaz

I have a sophos xg 125 firewall i have configured the wan port but when i connect the fiber cable to the WAN port its not blinking but the cable if put in the TP link WAN port and configure it it works . Both the wan port i have configured usinf the isp Ip address



This thread was automatically locked due to age.
Parents
  • 0

    hi Mohamed,

    looking at your last picture, I notice interface br0 = bridge interface, under this interface you have mapped physical sfp port 9. so get this port out of your br0 config and configure that port as type WAN with your provider information.

    good luck!

    cheers,

    Dimitri

Reply
  • 0

    hi Mohamed,

    looking at your last picture, I notice interface br0 = bridge interface, under this interface you have mapped physical sfp port 9. so get this port out of your br0 config and configure that port as type WAN with your provider information.

    good luck!

    cheers,

    Dimitri

Children