Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 4 replies
  • Subscribers 28 subscribers
  • Views 1565 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPv6 HowTo an XG v18

Mr.Roboto

Hi, ,

i have a problem with the introduction of IPv6 in various projects. Unfortunately IPV6 PD does not work, so I try to assign private networks and then route them via NAT into the WAN.
My problem starts already with IPv6 RA, this works only sometimes/sporadically. The DHCP works over the RA but the clients don't get a gateway anymore :/.
The clients are Windows 10 devices.

Is there a HowTo for stupid? I have the feeling I am missing something. If I only use the router advertisement with DHCP I had already managed that if I set the gateway statically a communication into the WAN via NAT works.

Thanks a lot :)

 

EDIT:

Minutes after posting this, my workstation obtained everthing as expected and is able to reach IPv6 on the WAN. :D
I dont get it, because i switched all checkbixex on and off and it wasn't working at all. It tested every possible situation.....
Crazy, but there still other XGs ith the same problem.....

 

EDIT AGAIN:

After Reboot of workstation again no IPv6 connectivity :(



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to Vishvas

    During further troubleshooting I found out that there seem to be problems with Intel WLAN cards, at least it now runs in the lab via LAN :=)
    Another PC is now working, yesterday it wont :/ It's quite a bad implementation, also logging is at the XG is not the finest. Palo did it much better!

    Thank your for the video, it helped me realize that I am not crazy ^^

  • 0 in reply to Mr.Roboto

    Hi Mr Roboto,

    whose WLAM devices are you using? If Sophos you can manage them from within the XG otherwise they are just another network device.

    Please be more specific about your WLAN issue. At this stage of XG development Sophos APs do not receive an IPv6 address to at the least the ones I use don't, this might have changed with the APX series devices.

    Ian