Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 27 subscribers
  • Views 2059 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to enable physical ports using cli?

Fluffy

Hello, we have a sophos xg firewall that the LAN port is destroyed. We cannot connect through it. But we can only configure the LAN and WAN port? What would be the beat solution for this. Eth 4 to 8 cannot be configured nor give dhcp addresses.



This thread was automatically locked due to age.
Parents
  • 0

    No, I can't access the GUI because we reimage the firewall and it has been reset to its default. Only the Eth 0 and eth 1 can be configured. eth 4 to 8 won't release IPs nor don't know If that port has a default IP because we can't view the interfaces. We cannot use the SSH then. 

  • 0 in reply to Fluffy

    Hello Fluffy,

    Thank you for the follow-up.

    If you factory reset the XG, eth0 should be configured with the IP 172.16.16.16, maybe you can't access via SSH, but can you console in and contact a Monitor to the back of the device, that way you could see and try to configure eth0 eth1.

    Regards,

Reply
  • 0 in reply to Fluffy

    Hello Fluffy,

    Thank you for the follow-up.

    If you factory reset the XG, eth0 should be configured with the IP 172.16.16.16, maybe you can't access via SSH, but can you console in and contact a Monitor to the back of the device, that way you could see and try to configure eth0 eth1.

    Regards,

Children
No Data