This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to block FQDN sites in IPv6?

Hi folks,

I have been testing a block setup for a forum member in another thread and could not successfully complete the test because of what I see as limitation in IPv6.

What I am after is a method of using FQDN in IPv6 firewall rules.

Fails.

1/. you cannot add an FQDN to the destination field

2/. IPv6 addresses do not appear in the GUI when you check FQDN, only IP4. So you cannot even generate list of IPv6 addresses to add manually.

The site concerned is teamviewer.

Your thoughts and suggestions please.

Ian

This thread was automatically locked due to age.

Parents

0 emmosophos over 5 years ago

Hello rfcat_vk,

Thank you for reaching out.

I will confirm and get back to you tomorrow but it does seems to be a limitation.

Are you using 17.5 or 18?

Regards,
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 5 years ago in reply to emmosophos

Hi Emmanuel,

I am using v18.0.2 mr-2.

i have asked similar questions in the past and been unofficially advised to wait for v18.0.5 mr5 I think or it might have been v18.5.x.

ian
Cancel
Vote Up 0 Vote Down

Cancel
0 emmosophos over 5 years ago in reply to rfcat_vk

Hello rfcat_vk,

Thank you for the follow-up.

I have reached out to Product Management to get more information on this, as there is no mention of which version will support yet. Once I hear back from them I will update this thread, but yes at the moment this is not supported.

Regards,
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 emmosophos over 5 years ago in reply to rfcat_vk

Hello rfcat_vk,

Thank you for the follow-up.

I have reached out to Product Management to get more information on this, as there is no mention of which version will support yet. Once I hear back from them I will update this thread, but yes at the moment this is not supported.

Regards,
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data