This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

LACP and Vlans

I have this configuration, a LACP of 2 phishical networks with 2 vlans

I want a server in 10.10.30.2 to see a server in 10.10.40.4

The only way I have achieve that is doing a rule from DMZ to DMZ any any any.... Any other combination without ANY's doesn't work,.

If I try to do this I can't even ping the machine, the problem is that #LACP is not a network, it just reffers to 10.10.30.1 and #LACP.40 is 10.10.40.1 so is not a network is the IP of the gateway.

Is there a way to configure wihtout adding an IP-Range that I want the 10.10.30.0/24 network to connecto to the 10.10.40.2/24 network, in a more elegant way? or should I create network in host and services?

This thread was automatically locked due to age.

0 rfcat_vk over 5 years ago

Hi,

seems a very complex way of linking servers. Now assuming they are MS servers they will be trying to use non routable protocols to communicate with each other?

Would that appear to be your issue?

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 l0rdraiden over 5 years ago in reply to rfcat_vk

I created network hosts now it works.

I do a lacp layer 3+4 to get the performance bonus and the vlans for security.

Servers with open ports are in one vlan the rest in the other one
Cancel
Vote Up 0 Vote Down

Cancel