This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

configure xg550 with 4 LAG ports connected to Cisco perimeter SW via ethernet

Good, we have in our infrastructure a perimeter SW with a 10 Gb output port to our ISP, and we would like to connect the currently 1 GB XG550, to this perimeter SW for the maximum number of LAG ports.

We have seen in the documentation that the LAG has a maximum of 4 port, but we do not know what type of configuration we have to apply in the XG 550, to connect the 4 ethernet network cables to our perimeter SW.

Data:
Cisco 3750 Edge SW

This thread was automatically locked due to age.

Parents

0 Vishal_R over 5 years ago

Hi Licencias AGAPA AGAPA

From the same KBA which you have already referred, you may follow "Prerequisites" and "What to do" section in terms of XG end LAG configuration. No any other hidden CLI command or kind of configuration.

https://community.sophos.com/kb/en-us/123100

https://docs.sophos.com/nsg/sophos-firewall/v16058/Help/en-us/webhelp/onlinehelp/index.html#page/onlinehelp/LinkAggregationEdit.html
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Vishal_R over 5 years ago

Hi Licencias AGAPA AGAPA

From the same KBA which you have already referred, you may follow "Prerequisites" and "What to do" section in terms of XG end LAG configuration. No any other hidden CLI command or kind of configuration.

https://community.sophos.com/kb/en-us/123100

https://docs.sophos.com/nsg/sophos-firewall/v16058/Help/en-us/webhelp/onlinehelp/index.html#page/onlinehelp/LinkAggregationEdit.html
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data