Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 26 subscribers
  • Views 380 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED Site-to-Site

cyberguy

Hello,

I'm using a site-to-site RED; with DHCP on interface by HQ.

 

Everything is working, but when the device in the Brench Office surf on Internet goes with Brench WAN.


How can I set to route all traffic, Internet included on RED interface and goes with HQ WAN?

 

Thanks,



This thread was automatically locked due to age.
Parents
  • FormerMember
    0 FormerMember

    Hi  

    Thank you for reaching out to the Community! 

    On your BO firewall, you could change the static route to send all the traffic to the HQ. 

    Have you tried to change the destination network to 0.0.0.0/0 in BO static route? You would also have to create a firewall rule to allow traffic from BO to WAN on your HQ firewall.

    Thanks,

Reply
  • FormerMember
    0 FormerMember

    Hi  

    Thank you for reaching out to the Community! 

    On your BO firewall, you could change the static route to send all the traffic to the HQ. 

    Have you tried to change the destination network to 0.0.0.0/0 in BO static route? You would also have to create a firewall rule to allow traffic from BO to WAN on your HQ firewall.

    Thanks,

Children
No Data