Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 27 subscribers
  • Views 1126 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WAN TO DMZ not working

Ash parkar

Hello Experts

 

I am new to sophos XG , and I am using sophos SFOS 18.0.0 GA-Build379.HF052220.1) , I am trying to make communication between the wan and dmz zone. Below is my network setup configured on virtual box. I am able to communicate between LAN and DMZ for that I have configured DNAT but when I use same technique for WAN to DMZ its not working .I am trying to ping from my 192.168.112.30 to DMZ server ip 10.0.3.10. DMZ networks service for ping is enabled in system administration >> Device access.

Virtual Machine

Firewall Ports

Networks

LAN(Inet)

Adapter 1 (Inet)LAN

172.16.16.0/24

Mgmt Pc(Bridge)

Adapter 2 (Bridge)WAN

192.168.112.0/24

Server (DMZ)

Adapter 3(DMZ)DMZ

10.0.3.0/24


This thread was automatically locked due to age.
Parents
  • 0

    Do you have a firewall rule to Allow traffic between following 2 zones? 

    Source (Mgmt)

    Destination(DMZ)

     

    (I don't have your setup, but I have a LAN to DMZ rules which was required to ping from LAN to DMZ, I assume, your Mgmt should be similar).

     

Reply
  • 0

    Do you have a firewall rule to Allow traffic between following 2 zones? 

    Source (Mgmt)

    Destination(DMZ)

     

    (I don't have your setup, but I have a LAN to DMZ rules which was required to ping from LAN to DMZ, I assume, your Mgmt should be similar).

     

Children
No Data