VLAN problem with Unifi and 1920s

Hi,

are the VLANs setup in the 1920 as tagged at the XG connection and untagged at the user connection?

I assume you are using VLAN1 as an example, you cannot have multiple VLAN1.

Ian

Hi,

  Yes they are tagged at uplink and untagged at user side.

  And alas VLAN1 here was just naming, I used 30 and 40. I'll try without bridge tomorrow but other than I'm quite clueless.

Hi,

the XG uses L3 VLANS, where as the default for Cisco is L2.

Ian

I checked HP 1920S , apparently has L3 capabilities.

I will try if getting rid of bridge will help since apparently there is no connection issue but port gets IP lease from AP pool so I'm optimistic that separating LAN ports will help.

If not, to be seen :)

I can tell you multiple VLANs on one interface work.  I have a customer where LAN1 is tagging 2 VLANs (51/52) and an untagged VLAN (50).  These are going to a HP 1910 switch.  On the 1910 switch I have the exact setup as the XG230 (PVID on the 1910 is set at 50 as well).

I handled problem by bridging VLANs separately, now all of them work just fine. Thanks for help.

I handled problem by bridging VLANs separately, now all of them work just fine. Thanks for help.