Thread Info
  • State Suggested Answer
  • +6 person also asked this people also asked this
  • Locked Locked
  • Replies 47 replies
  • Answers 4 answers
  • Subscribers 46 subscribers
  • Views 25664 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

v18 MR-1 killing all traffic

Gary Parr

I loaded MR-1, everything was fine for a while then suddenly all traffic dropped. I could still get into XG itself and nothing looked wrong, so I thought it was an upstream device. I rebooted those but still nothing. Rebooted XG and suddenly everything started working again. No more than 15 minutes later, all traffic died again. This time I spent some time looking at the XG logs but nothing stood out. No services were reported down and all interfaces and gateways reported as up. I have since reverted back to GA build 354 and all again is right with the world. When I have some time I can push MR-1 back on and dig some more, but wanted to share in case anyone else has had a similar experience.



This thread was automatically locked due to age.
Parents
  • 0

    I had this problem after upgrading to MR-1 on our home Sophos setup (mini-PC) - everything just died - reboot and fine for another 8-12 hours or so.  Have rolled back to previous v18.0 345 software release.  But another push for better QA please - this is our house firewall so two people working from home and two kids who connect with their mates and school via this.

    Normally would have waited, but since last week the AV definitions setup broke and needed some Advanced shell tinkering to fix, I thought it best to update - assuming that problem would then be properly fixed...

    Caution please guys.  

    Paul

Reply
  • 0

    I had this problem after upgrading to MR-1 on our home Sophos setup (mini-PC) - everything just died - reboot and fine for another 8-12 hours or so.  Have rolled back to previous v18.0 345 software release.  But another push for better QA please - this is our house firewall so two people working from home and two kids who connect with their mates and school via this.

    Normally would have waited, but since last week the AV definitions setup broke and needed some Advanced shell tinkering to fix, I thought it best to update - assuming that problem would then be properly fixed...

    Caution please guys.  

    Paul

Children
No Data