This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VLAN / DHCP

I have 3 VLANS, along with DHCP set up for each one.

My Sophos is 10.0.0.1, and I'd like VLAN11 to be on the 10.0.0.x network, so I've configured it as so...

However, when I plug a new device into the network, it gets put on the 169.254.x.x network, instead of picking up the 10.0.0.x/VLAN11.

I know I am missing something super obvious but the Sophos interface is brand new to me after getting away from Netgear.

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 5 years ago

Hi,

very simple, the VLANs are on your external interface and need to be on your internal interface and managed through a managed switch.

I do not understand your configuration as to why you are using a bridge connection?

Ian

XG115W - v19.5.1 mr-1 - Home

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Regex over 5 years ago in reply to rfcat_vk

I have to disagree. I just deployed sophosOS for a new machine with one external PCI 4NIC card and there was no bridge - each port woks as separated interface. Or maybe i didnt know how to config it as one LAN -> 1,2,3interfaces as one LAN

__________SETUP___________

HP Small Form Factor: i5 4Cores, 8Gb of RAM.
Intel Network Card 5x Eth
SSD: 256Gb
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Regex over 5 years ago in reply to rfcat_vk

I have to disagree. I just deployed sophosOS for a new machine with one external PCI 4NIC card and there was no bridge - each port woks as separated interface. Or maybe i didnt know how to config it as one LAN -> 1,2,3interfaces as one LAN

__________SETUP___________

HP Small Form Factor: i5 4Cores, 8Gb of RAM.
Intel Network Card 5x Eth
SSD: 256Gb
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data