Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 3 replies
  • Answers 1 answer
  • Subscribers 26 subscribers
  • Views 473 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Setup A Static IP on XG310 for Management

tripleview

Our production firewall is an XG310, but we also have an SG310 as a backup.

On the backup, I have setup routing and firewall rules in case something happens with the production firewall. In an emergency I can unplug the LAN and WAN cables from the prod XG and plug into the backup SG.

I would like to have a static IP assigned to another port on the backup SG that I can use for configuration and firmware patches. How do I go about setting this up?

Thank you.



This thread was automatically locked due to age.
Parents
  • 0

    tripleview,

    you can configure an unused port on XG, configure an IP address and put into LAN or create a new zone. If you create a new ZONE, make sure to enable HTTPS management checkbox for the new zone under Administration > Device Access.

    Regards

Reply
  • 0

    tripleview,

    you can configure an unused port on XG, configure an IP address and put into LAN or create a new zone. If you create a new ZONE, make sure to enable HTTPS management checkbox for the new zone under Administration > Device Access.

    Regards

Children