Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 5 replies
  • Subscribers 27 subscribers
  • Views 838 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WAN to LAN server

Jay Kelly

Hello,

I am attempting to route multiple WAN IP addresses to multiple internal LAN servers. For example, I have 10.1.1.10 as my primary MASQ route for all internet access. I created an alias on the same interface and used 10.1.1.11 which has a firewall rule pointing to 192.168.1.11. When I browse the internet from 192.168.1.11 I show my external IP is 10.1.1.10 however I need it to be 10.1.1.11. I tried creating another MASQ route but didn't see any change. 

 

Any suggestions?

 



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to Jay Kelly

    Hi Jay,

    is the 10 address your real external address or just n example? If it is the real address that means you have another modem performing NAT between the XG and the ISPs network.

    Please provide a diagram of what you are trying to achieve and your network interface configuration.

    Ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    Hello,

    The 10 address was just an example. below is what I'm wanting to accomplish.

     

    Each internal server should translate the external IP in/outbound traffic to the internal LAN.

  • 0 in reply to Jay Kelly

    Hi Jay,

    thank you for the diagram, makes assistance so much easier.

    Please try using WAF for your external facing servers.

    Ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

Cookie Information Banner