Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 7 replies
  • Subscribers 28 subscribers
  • Views 929 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

no access after hardware exchange

Tarzan

After a hardware swap, I can't get into the firewall anymore.
I am using a test environment with the XG Home. I have plugged the hard disk from a working system into another computer. If I connect a monitor to the new computer, I see that the firewall starts normally. On the computer the LEDs on port 1 are off. When I log on to the console and go to the Network config menu a message appears Initializing Please wait. What can I do?



This thread was automatically locked due to age.
Parents
  • 0

    Hi Tarzan,

    are you swapping the same hardware or differenz hardware?

    Maybe the new hardware is not supported and the system is waiting for timeout.

    When the LEDs on port 1 are off then the network is not up. Is the physical network device ok (boot with a linux runtime version)?

    Best regards,

    Bernd

Reply
  • 0

    Hi Tarzan,

    are you swapping the same hardware or differenz hardware?

    Maybe the new hardware is not supported and the system is waiting for timeout.

    When the LEDs on port 1 are off then the network is not up. Is the physical network device ok (boot with a linux runtime version)?

    Best regards,

    Bernd

Children
  • 0 in reply to BeEf

    the new hardware is basically the same.
    If I connect a monitor to the computer of the firewall I can see that the system starts normally. When I enter the admin password I see the menu. Under Network is only Init... please wait. I cannot access the network settings.

    The hardware is fine. There is something about the software