Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 7 replies
  • Subscribers 28 subscribers
  • Views 929 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

no access after hardware exchange

Tarzan

After a hardware swap, I can't get into the firewall anymore.
I am using a test environment with the XG Home. I have plugged the hard disk from a working system into another computer. If I connect a monitor to the new computer, I see that the firewall starts normally. On the computer the LEDs on port 1 are off. When I log on to the console and go to the Network config menu a message appears Initializing Please wait. What can I do?



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to Keyur

    Here's what I did:
    -old hard disk installed in another computer
    -System starts normally
    -System update performed on 17.5.9 MR-9
    after the reboot the system was no longer accessible via the LAN Port1. At LAN Port2 the LEDs are still blinking.

  • 0 in reply to Tarzan

    Looks like the hardware on LAN Port 1 is not supported by 17.5.9 MR-9.

    What is the hardware of the two ports? Are thery different?

    There is a bridge between LAN Port 1 and LAN Port 2 (should be)? Remove the bridge of  LAN Port 1 and LAN Port 2 and recreate it.  

    Maybe creating a backup and do a direct install of 17.5.9 MR-9 will help ...