This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DHCP is not working correctly with two LAN

Hello , I’d like to share with you my DHCP issue I have two interfaces LAN with different network IP on site Sophos xg125. Last days I found some of users from LAN 1 took IP from DHCP of LAN2 After log off DHCP and login they took correctly IP from DHCP of LAN 1 So I need how can I solve it?

This thread was automatically locked due to age.

Parents

0 Keyur over 5 years ago

Hi Mohamed Adly

Could you please share your network diagram?

Both the networks are connected to the same switch and switch is connected to a single Interface of the XG firewall or Both the networks connected on separate Interface of the XG firewall.

Could you please try to execute the below command and check?

Login to the command line interface (CLI) and choose option 4. Device Console to run the following command:

system dhcp static-entry-scope global
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 5 years ago in reply to Keyur

Mohamed,

can you tell us the ip addresses for each LAN interface? Also, please share the DHCP configuration.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
0 Mohamed Adly over 5 years ago in reply to lferrara

I already run this command but I can’t see any messages. IP address LAN 1 is 10.10.10.0 LAN 2 192.168.4 .0
Cancel
Vote Up 0 Vote Down

Cancel
0 lferrara over 5 years ago in reply to Mohamed Adly

Ok. Please enter:

system dhcp static-entry-scope show

Thanks
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 lferrara over 5 years ago in reply to Mohamed Adly

Ok. Please enter:

system dhcp static-entry-scope show

Thanks
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 Mohamed Adly over 5 years ago in reply to lferrara

Sure I Did it

and this is the result.

console> system dhcp static-entry-scope show                                    
global                                                                          
console>