Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 3 replies
  • Subscribers 26 subscribers
  • Views 1663 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Multiple VPN's Using Same Subnet

Gregory Williams

We have two IPSec VPN's configured and working. One of the remote sites added a new subnet with the same range used in the other VPN. Traffic flows fine over one tunnel, but of course doesn't route to the other tunnel addressed to the same range. Neither remote site wants to or is willing to NAT the range. Are there any options on the XG to NAT the inbound traffic from one of the tunnels?



This thread was automatically locked due to age.
Parents
  • +1

    Hi  

    I don't think it would be possible to NAT the inbound traffic specific from that IPsec tunnel. Since traffic would be coming from VPN zone, it would not be possible to distinguish the traffic in Firewall rule to determine from which tunnel it came from. This does not seem possible to me.

Reply
  • +1

    Hi  

    I don't think it would be possible to NAT the inbound traffic specific from that IPsec tunnel. Since traffic would be coming from VPN zone, it would not be possible to distinguish the traffic in Firewall rule to determine from which tunnel it came from. This does not seem possible to me.

Children