This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED device with an XG firewall on Azure

Hi All.

I'm configuring a RED device on a XG firewall on Azure.

I followed the steps reported on this video https://vimeo.com/210692008 with these final results: from the RED I'm able to ping the interfaces (LAN and WAN) of the XG firewall on Azure but I'm not able to go out on internet (failed to ping 8.8.8.8).

Thank you in advance for your help or suggestions.

Regards,

This thread was automatically locked due to age.

0 LuCar Toni over 6 years ago

Which RED Mode do you use and do you have a LAN(RED) to WAN Rule with MASQ?
Cancel
Vote Up 0 Vote Down

Cancel
0 mic83hele over 6 years ago in reply to LuCar Toni

Thank you for your response.

Yes, I created a RED to WAN rule with MASQ and the RED mode is a standard split.
Cancel
Vote Up 0 Vote Down

Cancel
0 Amelia davis over 6 years ago

Hi,

It seems like an ARP issue.

https://appsync.biz/dafont/ https://showbox.bio/ www.oovoo.onl/.../
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni over 6 years ago in reply to Amelia davis

You should start to dig into the Dumps to get a clue, which interface / route could cause this issue.

https://community.sophos.com/products/community-chat/f/knowledge-base-article-suggestions/105811/how-to-tcpdump-on-xg
Cancel
Vote Up 0 Vote Down

Cancel
0 mic83hele over 6 years ago in reply to LuCar Toni

Thank you guys but I solved the issue a few weeks ago.

All the best,

Michele
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 6 years ago in reply to mic83hele

Hi Michele,

Please share your solution.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 mic83hele over 6 years ago in reply to BAlfson

Yes sure.

Just changed the RED operation mode (Standard Unified).

Added a firewall rule (LAN-RED to WAN) with MASQ.

All work fine now.

Thanks.
Cancel
Vote Up 0 Vote Down

Cancel