This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Static Routing on XG210

Hi I am struggling to configure a static route on my XG 210 hardware device  

it is configured as follows :

WAN Port static:            192.168.199.101

Default Gateway:          192.168.199.100

Subnet mask:                  255.255.255.0

 

LAN Port: 10.1.1.1 (static)

DHCP (Range 10.1.1.0) distributed by the LAN port



This thread was automatically locked due to age.
Parents
  • Why do you think you need a static route? Why don't you use a firewall rule?

    Ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

  • I have created a LAN to WAN rule as shown above but  i am still getting a DNS connection error and bellow are my port configurations

  • DNS connection will not be fixed by routing. How do your network devices get their DNS settings from? Does the XG have a DNS setting that points to a real word DNS because the setup sounds like your gateway does not have a correct DNS setting?

    If you do a DNS test from the XG diagnostics tab what are the results?

    Ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

Reply
  • DNS connection will not be fixed by routing. How do your network devices get their DNS settings from? Does the XG have a DNS setting that points to a real word DNS because the setup sounds like your gateway does not have a correct DNS setting?

    If you do a DNS test from the XG diagnostics tab what are the results?

    Ian

    XG115W - v19.5.1 mr-1 - Home

    If a post solves your question please use the 'Verify Answer' button.

Children