This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG in transparent bridge

I have pfSense as a router and am trying to make XG my transparent UTM on a separate host with three NICs and two configured in bridge however when I connect to the LAN side I cannot access the gateway or the internet. Help?

This thread was automatically locked due to age.

0 Bingo over 9 years ago

I spent 4 hours getting this "thing" up and running and ran into the same problem. Back and forth re changing cables and then finally redoing the wizard once the port 1 and port 2 was figured out. I have pinned down cables that need to set the same way as UTM9. Default here was opposite to what I had on UTM9. Had a hell of a time getting this thing up in transparent bridge. It is but not enough control. Where do I turn off the proxy when some program updates need to be done and the proxy smokes the update?
Cancel
Vote Up 0 Vote Down

Cancel

XG in transparent bridge

Submitted a Tech Support Case lately from the Support Portal?