Hello Everyone,
Here again with the same issue that i experienced with the past firmware versions. The thing is...after applied the firmware 17.1.4-MR4 the device starts consume too much swap (about 90% to 98%), this is very annoying because it fails sometimes on the networking module and lost all NAT functions. To recover the operation we reboot the device, but the SWAP usage still increase time to time, about 3 weeks and reach the 98% fluctuating 90 to 98%.
A few months ago i started a thread that some ppl recommends me to update the firmware, but the swap usage still increase and cause to fail the correct device operations. Additionally i've disabled some services and modules with no use and some log options but without not change.
Here is the output of the TOP commands and the difference with the hardware resources usage of the graphic interface that i not understand and is very confuse:
Module that i disabled:
Logs disabled:
Waiting for replies and some help
Best regards!
This thread was automatically locked due to age.
