This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Specific NAT on XG Firewall not work but MASQ that works.

Hi everyone,

i am configuration specific NAT on XG Firewall not work but MASQ that works.Please help me.

Source Zone : DMZ
Source IP 10:102.113.46
Dest. Zone : LAN
NAT IP : 172.25.3.94
Destination Target 172.29.84.26
Test Result
SNAT : Time out...
MASQ : It's work.

PS. I think about routing.That's got nothing to do with it because the old firewall(Linksys) it's work on this topology.

This thread was automatically locked due to age.

0 rfcat_vk over 6 years ago

Probably should a destination NAT and add some port translations if you want NAT to work.

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 Thanakorn Ruangsri over 6 years ago in reply to rfcat_vk

Thank you for you reply.How to config it.
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni over 6 years ago in reply to Thanakorn Ruangsri

I cannot follow your requirements.

Can you draw a picture with the wanted traffic flow?
Cancel
Vote Up 0 Vote Down

Cancel
0 Thanakorn Ruangsri over 6 years ago in reply to LuCar Toni

Hi Lucar,

Flow is :
Cancel
Vote Up 0 Vote Down

Cancel