How to configure the new Sophos Connect VPN in 17.5

I have the same problem it don´t works, my SSL VPN works fine.. i have make with then : 

https://community.sophos.com/kb/en-us/133109#Configuration

I can connect it after but i don´t  see any thing, no intern websites or any another website so i think it ist a problem of the dns 

Same here Seems the document is less than helpfull

Yeah, I was using that too. The docs are less than helpful on what the IDs are supposed to be. It would be nice if Sophos would give a better walkthrough, would love to use this over the SSL vpn.

Hi,

The Sophos Connect Client is in EAP. 

Here is an Guide: 

https://community.sophos.com/kb/en-us/133109

Plus this :

https://community.sophos.com/products/xg-firewall/sophos-xg-beta-programs/sfos-v17-5-early-access/f/sophos-xg-17-5-early-access/108551/using-sophos-connect-vpn-client

The current V17.5 simply renamed the old Cisco VPN tab. 

https://community.sophos.com/kb/en-us/123136

So basically everything is used like before. 

Yes this basically was sure, but is don't work! 

I have Connection to my Sophos but i don't can ping any Host!

The section that talks about an IP pool for client and is not real clear, From what I understand, and correct me if I am wrong, you assign in the pool a few address from the Firewall Local LAN network so that when you connect you can access that network. Anyway I tried it both ways, assigned it at IP from Firewall LAN and made IP address from another network and nether one allowed me to access the internal LAN.

Both times I was able to connect but could not ping or connect to any devices in the LAN, Are there firewall rules or some other configuration to is needed?

I got mine working, after it was explained that it was a Cisco VPN. I assigned a random IP from the class b network. And then my firewall rules for VPN worked just fine. I am able to use the sophos client to connect my Mac to the XG. I will start rolling this out to the test group, hopefully its faster than the SSL vpn connection were currently using.

Can you post a acreenshot af the fw rule and connect client setup page?

I must be missing something out, as I cannot get any traffic through the tunnel at all, it's like it's not being routed at all.

Connection works fine, traffic counters just remain at 0 :-(

Here is my setup. 

Sophos connect tab

This is the FireWall Rule Zone VPN to my other Zones and WAN (Since its full tunnel)

I set this up on our LAB XG and didn't even need a firewall rule to allow the connect clients access to the LAN. I only have a single firewall rule, default LAN to WAN. I created a small subnet range (different from the internal LAN) within the connect client setup. I see you guys created firewall rules, is that to restrict access?

I set this up on our LAB XG and didn't even need a firewall rule to allow the connect clients access to the LAN. I only have a single firewall rule, default LAN to WAN. I created a small subnet range (different from the internal LAN) within the connect client setup. I see you guys created firewall rules, is that to restrict access?

I have that rule in place to allow access to the different vlans for the SSL VPN assumed that same VPN rule was being used by Client Connect.