Hi guys & dolls,
I have XG210 and XG135 firewalls which I access either through LAN when in office or through public static IP when around.
Can I set the device to allow logins only for my country?
Thank you in advance for your help.
Regards,
Ronald
I'd advise against this however it is possible see the bottom of the page of the link below, you should be able to set the source to your country
+1 for kieran90 Here's the direct link to that section for the lazy.
Deny HTTPS on your WAN zone
Then create an exception rule with the source set to the country object, the destination as your XG's WAN Public IP, and the service set to HTTPS.
Regards,
+1 for kieran90 Here's the direct link to that section for the lazy.
Deny HTTPS on your WAN zone
Then create an exception rule with the source set to the country object, the destination as your XG's WAN Public IP, and the service set to HTTPS.
Regards,
