This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IP Alias + 1:1 NAT how to?

I just setup the KVM Appliance and i'm having trouble with setting up multiple public IP's and using 1:1 nat to forward those addresses to VM's behind the firewall. This is the first time i've used any sophos firewall software. What I've done so far is create an IP Alias under my WAN Interface (PortB:0). I then created a firewall policy with the non-http based policy template. Here is a screenshot of the created rule: http://i.imgur.com/35Wtl4h.png Unfortunately this does not work. I'm not really sure what to do now. I enabled icmp ping on the firewall for testing and i'm able to ping the firewall IP fine, but unable to ping the Alias IP.

Thanks for any help!

This thread was automatically locked due to age.

Parents

0 AntonioPallua over 9 years ago

Hi bobdole, I have a similar problem. If you have not given up, you can try this console command:

arping -s ALIAS_IP -c 5 -I PortE1 GATEWAY_IP

and then check if it works.

Sophos Support found (in my situation) a problem with arp table.

--AP
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 AntonioPallua over 9 years ago

Hi bobdole, I have a similar problem. If you have not given up, you can try this console command:

arping -s ALIAS_IP -c 5 -I PortE1 GATEWAY_IP

and then check if it works.

Sophos Support found (in my situation) a problem with arp table.

--AP
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

IP Alias + 1:1 NAT how to?

Submitted a Tech Support Case lately from the Support Portal?