Bridged LAN and WAN as default setup? Why?

Hi,

 I would expect you have answered the question about bridge etc incorrectly. You are asked how you would like your XG configured as part of the initial setup.

Ian

Where it says choose gateway I put "route mode"

You have to hit continue twice and hit skip to finish to avoid it bridging these two interfaces. No idea why.

Hi Greg,

sounds correct. What browser are you using? I use IE when doing builds because the PC is connected to the shared display I use for the XG console.

Ian

I've been using Chrome.

The reason is explained in the plain text above in routing wizard.

(Software Appliance - If you use a hardware appliance, all interfaces are "selected" per default. You have to disable this.) 

The reason is explained in the plain text above in routing wizard.

(Software Appliance - If you use a hardware appliance, all interfaces are "selected" per default. You have to disable this.) 

Hi LuCar,

so what you are advising if you only select one port during initial setup the XG will not go into bridge mode.

Ian

Yes for sure. 

It is just a default setting, which we wanted to set for the customer. 

Most of them are happy with this, because they do not have to do anything in Case of initial setup. 

Smaller boxes are most likely to bridge together. 

As far as i know, we will build a extra popup for this in the wizard. Because in XG you have to do some kind of extra steps to break the Bridge, which is not nice.