This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Initial setup issues of XG 125w rev.2 hardware appliance

I am unable to ping the device on 172.16.16.16, I have tried to connect wan port to my netgear router and straight to the modem. I have tried static assign my network adapter, I have tried to dhcp. Nothing appears to work.

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 6 years ago

Hi,

the external port should be connected to your internet device, try without nether router in place. When you connect your PC to the internal connection you should be assigned an IP address, check your PC LAN card is set to auto detect connection type/speed.

Ian
Cancel
Vote Up 0 Vote Down

Cancel
0 thomas putnam over 6 years ago in reply to rfcat_vk

yeah it is, it wont work. I cant even get the console port to work.
Cancel
Vote Up 0 Vote Down

Cancel
0 thomas putnam over 6 years ago in reply to thomas putnam

When connected to my router, it does get an ip address I noticed though. The WAN is definitely setup as DHCP.
Cancel
Vote Up 0 Vote Down

Cancel
0 thomas putnam over 6 years ago in reply to thomas putnam

Since, I have revision 2 was the default gateway 172.16.16.16 something different? 18 months ago, I did get into the initial setup, but unable to register because a friend purchased it and we took forever to move the license. Finally did and now unable to reach any info on the gateway at all.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 thomas putnam over 6 years ago in reply to thomas putnam

Since, I have revision 2 was the default gateway 172.16.16.16 something different? 18 months ago, I did get into the initial setup, but unable to register because a friend purchased it and we took forever to move the license. Finally did and now unable to reach any info on the gateway at all.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data