XG FIREWALL A RED 15W

Hi Marcos Ramirez 

Would it be possible to further clarify your setup?

Are you referring to connecting via VPN (SSL?) to your head office's XG firewall and then connecting to the DVR on the RED remote site?

HELLO,
I WOULD BE ABLE TO CONNECT ME FROM MY CENTRAL OFFICE TO THE SECONDARY OFFICE
THROUGH THE NETWORK-15W AND SO I CAN VISUALIZE FROM MY CENTRAL OFFICE THE CAMARAS OF SAID OFFICE.

CURRENTLY WE HAVE IT CONNECTED BY A NETGEINE AND A CYBEROAM BY MEANS OF IP SEC
THIS IS HOW FROM THE CENTRAL OFFICE WE CAN DISPLAY THE CAMERAS OF THE SECONDARY OFFICE.

Hi Marcos,

As LuCar mentioned above, please take a look at our RED technical training KB for more info.

All 3 options are valid, however the setup choice is yours as per your network requirements.

Hello again.
Which option would be the best, if I want the network-15w to take the internet from a modem in the secondary office and not from the central firewall.

I have configured it in the standard / unified mode with an ip destination destined for that office, I have activated the wifi network too, since my xg-230 I can see online the network-15w but when I connect any device either by LAN or wifi has internet access.

I have created a firewall rule in the following way:

origin
lan -----> red15w ----> always

destination
wan ----> anyone -----> anyone

in nat and routing I have selected masq
and I have put my ip addresses (primary, reservation) that are those of my central firewall

What is wrong? help

Hello again.
Which option would be the best, if I want the network-15w to take the internet from a modem in the secondary office and not from the central firewall.

I have configured it in the standard / unified mode with an ip destination destined for that office, I have activated the wifi network too, since my xg-230 I can see online the network-15w but when I connect any device either by LAN or wifi has internet access.

I have created a firewall rule in the following way:

origin
lan -----> red15w ----> always

destination
wan ----> anyone -----> anyone

in nat and routing I have selected masq
and I have put my ip addresses (primary, reservation) that are those of my central firewall

What is wrong? help

Hi Marcos,

You would want to configure your RED tunnel in Standard/Split Mode assuming that you also want the XG to manage the remote network (DHCP).

• Only traffic for selected networks is sent through the tunnel. All other traffic is sent directly out the local internet connection.

Follow the procedure outlined in this section to configure your firewall rules.

IT WAS ACCEPTED TO ESTABLISH A RULE IN FIREWALL ACCORDING TO THE AREA WHERE THE NETWORK IS (LAN) AND EVEN SO I HAVE HAD NO INTERNET CONNECTION, NOR WIFI SINCE I ALSO HAVE ACTIVATED THE WIRELESS. I DO NOT KNOW WHAT CAN BE

Hi Marcos,

Would it be possible to enable the support access tunnel on your appliance and PM me with your access ID so I can investigate further?

Thanks,

Hello good day, of course yes, some specific hours? since I would like to know what was the detail