Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 26 subscribers
  • Views 7068 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Is it possible to change the failover method in a link aggregation group?

Tommaso Zanetello

I have setup a link aggregation in active-backup mode on two WAN interfaces of my XG firewall. When primary data connection fails the firewall still sees the gateway up and so it doesn't switch up the backup interface. Is there a way to change the default failover rule and set a custom one, for example a ping to 8.8.8.8?



This thread was automatically locked due to age.
Parents Reply
  • 0 in reply to Ronak Sheth

    Hello Ronak,

    thank you for your reply.

    I can't change the failover rule from Network->Wan Link Manager, because I have configured the interfaces in link aggregation, and so I now have only one gateway.

    I can't configure the two interfaces as stand alone, because the IP configuration of the gateways behind the interfaces is the same (same IP, same netmask and same gateway).

Children