AP50 WAPs only active if "system appliance_access enable" is set.

Hi, everyone. I finally got my AP50s up and running on XG. I am now running into an issue where the access points are only able to be seen by XG if "system appliance_access enable" it set. As soon as I set it to disable, they disconnect.

Here is a relevant log from the firewall when I set disable:

During testing, i have set the firewall to: 

Even with this the APs don't work. 

In "Administration < Device Access" I have wireless protection device access enabled for LAN and WiFI

In "Configure < Network < DHCP" I have the LAN address as DHCP (which is also the admin interface) and "use interface IP as gateway." As long as "appliance_access enable" is set, the access points pull a DHCP IP address.