High CPU-load with SFOS 17.1.2 MR-2 and HA

Question

Hi, 
 since updating to SFOS 17.1.2 MR-2 a customers XG HA-cluster in A/P mode is ~90% cpu load. 
 Its a small XG125 setup. 
 Anybody seen this before?:

dna · Accepted Answer

This issue occurs only if the RED feature is enabled and at least one RED interface is connected. 
 The more RED interfaces are used, the heavier the issue occurs. Also happens on non-HA setups. 
 It will be fixed in v17.1.MR3.

Argo · Answer

do the logs provide any details?

FloSupport · Answer

Hi onward 
 Apologies for this continued inconvenience, this high CPU issue caused by gethainfo process could be related to NC-36927 . Have you already raised a support case for further investigation? If so, please PM me with your support case ID for follow up. 
 To our community, 
 If you are also experiencing similar symptoms, please raise a support case and PM me with your ID for follow up. 
 Regards,

FloSupport · Answer

To update this thread for our community: 
 This KB article has been published regarding this issue . 
 Regards,

onward · Answer

SFOS 17.1.3 MR3 Released