DHCP_Port2_GW has wrong address since SFOS 17.1.2 MR-2

Hey Michael Bryenton 

Apologies for this inconvenience, would it be possible to enable the support access tunnel and PM me with the ID for further investigation?

Thanks!

Hi,

what type of link is your WAN? If it is an ADSL type service then the gateway more than likely will be in a different sub-net. The wan link manager is red because the gateway is not valid, have you tried refreshing the interface?

Ian

Done. I have never used this support access tunnel before. How does it work?

WAN link is PPPOE. WAN address is 70.X.X.X and DHCP_PORT2_GW is 10.X.X.X. Address was correct before the update.

Sounds like you have a modem in routing mode not bridge mode and the address will not change unless you restart your modem/router.

Ian 

For our community,

If you are experiencing the same issue, please investigate what rfcat_vk mentioned above.

You may also want to contact your ISP to confirm the details of your PPPoE configuration.

Regards,

The configuration offers the possibility to enter a preferred IP. Could this have helped instead of switching to static IP?