This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Firewall rules not working after reboot

After a reboot or HA failover we have a bunch of firewall rules not working. The rules are DNAT rules where the "protected host" is a FQDN host. Some of the rules also have the destination (listening ip) as a FQDN host. First I thought the latter might be the cause of the issue, but even when I set this to a (eg) "#PortE1" address it still has the same problem. If I open and then save the rule it starts working.

Is using FQDN hosts as the destination or protected server address supposed to work?

Thanks

James

This thread was automatically locked due to age.

Parents

0 FloSupport over 7 years ago

Hey jamesharper

Apologies for this inconvenience, have you already resolved the affected firewall rules? I would like to investigate this further with you.

Regards,
Cancel
Vote Up 0 Vote Down

Cancel
0 jamesharper over 7 years ago in reply to FloSupport

I would welcome your assistance. Right now I am waiting for HA failover to complete - 20 minutes and still waiting.

Are you asking to see the device in a state where firewalls are not working?

Thanks

James
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 jamesharper over 7 years ago in reply to FloSupport

I would welcome your assistance. Right now I am waiting for HA failover to complete - 20 minutes and still waiting.

Are you asking to see the device in a state where firewalls are not working?

Thanks

James
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data